Johnstown holds duct systems to a tighter leakage limit than the model code. A duct system that passes in the
HVAC SERVICES IN JOHNSTOWN NORTHERN COLORADO
Johnstown spans Weld and Larimer counties at about 4,850 feet, and it holds duct systems to a tighter leakage limit than the model code its neighbors use. Homegrown Heating and Air Conditioning provides HVAC services in Johnstown for repair, replacement, maintenance and duct work on furnaces, air conditioners and heat pumps. We measure static pressure and leakage rather than guessing at them, and we price the job before we start.
NO BRAND LOYALTY, JUST GOOD EQUIPMENT
BRANDS WE INSTALL AND SERVICE
We repair every major brand, whether or not we installed it. On replacements we recommend based on your load and budget, not on whose rebate is best this quarter.
WHERE WE WORK
HVAC SERVICES ACROSS NORTHERN COLORADO
If you’re in NoCo, you’re in our neighborhood. We drive to you fast, and with the common furnace parts already on the van.
GOOD TO KNOW
JOHNSTOWN HVAC QUESTIONS WE GET
Why is Johnstown’s duct leakage limit different from the town next door?
Johnstown amended the duct testing section when it adopted the 2024 codes, setting the limit at 4 cfm per 100 square feet with the air handler installed instead of using the model code table. Neighboring jurisdictions that adopted the model language without that amendment can allow more leakage on the same house.
Does replacing my furnace trigger a duct leakage test in Johnstown?
Usually not on its own. Under the 2024 energy code, an equipment swap by itself does not trigger a duct test. The trigger is an alteration that relocates 25 percent or more of the registers or of the total duct length, or grows the duct run by 25 percent or more, and the alteration threshold is a looser 12.0 cfm per 100 square feet. We tell you which side of that line your job falls on before we start.
Do I need a permit to replace a furnace or air conditioner in Johnstown?
Yes. Both are on the Town’s permit-required list, and both need a mechanical contractor and an electrical contractor licensed or registered with the Town. The inspection is a Mechanical Final.
Which utility serves Johnstown?
Xcel Energy provides both electricity and natural gas in Johnstown. That matters for heat pump rebates, because Xcel’s bonus rebate tier is not available where an existing electric system is the primary heat source.
What happens if an inspection fails in Johnstown?
A reinspection fee of $50 applies, and the job waits for the next available slot. Most failures we see are avoidable: the permit and approved documents were not printed on site, the address was not visible, or the equipment was not accessible. We handle the scheduling and the paperwork on our permits.
Do you seal existing ductwork, or only ducts on a new install?
Both. Sealing an existing system is often the highest-return work in an older Johnstown home, and on a replacement job we test and seal before we size the new equipment.
5-STAR SERVICE
WHAT YOUR NEIGHBORS SAY
Real reviews, from real Northern Colorado home owners
one call, and the cavalry rolls out
STAY WARM THIS WINTER. CALL YOUR NEIGHBORS.
No call centers. No pressure. Just honest answers, free estimates, and a stocked van on the way.